Vaping involves extreme heating either of liquid or solid that changes form of matter to a diffusing substance in the air, it entails inhaling of vapor. However, vaping is often related to electronic cigarette. To form the vapor and suspend the substance in the air for inhalation, an intensive level of heat is a requirement. The device we will focus on that makes this happen is the MOD. A MOD is considered a mechanical processing device because it does not involve circuiting. However, it’s key in determining the quality of the vaping process thus prior warming up of the MOD is necessary before beginning a vaping session. Warming up of the MOD before a vaping session is necessary just like in letting a car to warm up before driving especially during winter. The power and movement of a vehicle is primarily determined by circuits and fuel, letting a vehicle to warm up is critical in harmonizing all the processes thus optimum functioning of a car. Usually, this is necessary after a car has stalled for hours and maybe going for a long drive. Additionally, a MOD warm-up can be compared to a pitcher’s activities before a game. Baseball is a lively game that requires lots of energy constant throughout the game. Although it is true that a starting pitcher determines performance and enthusiasm of other players, at the end of it all, winning requires teamwork hence equal participation of each pitcher. To be able to contain pressure in the game and maintain a high level of output throughout necessitates prior practice. Just like in vaping, a warmed-up MOD would last longer and produce more in quality and amounts of vapor when the vaping switch is turned on immediately. Before a game, pitchers spend five to ten minutes in a preparation room exercising and stretching muscles. This is important to ensure the vigor at the beginning of the game is maintained as well as a pitcher does not pull off minutes into the game because of exhaustion or muscle pull. Quality and length of performance depend on prior preparation. Just like for an MOD device, a pitcher might last throughout a game, but the quality of output is guaranteed to be relatively low. A MOD might have been used on a previous day for the same vaping process and left to cool overnight for the next day’s session. Although switching it on and off may increase the MOD’s life, the subsequent sessions after long intervals would be of low quality and possibly low amount. It is important to begin the vaping process two to three minutes after MOD is switched on for heating. Similarly, for a pitcher, active participation in the field on the previous day does not guarantee the same level of performance quality on the following day. Irrespective of the pitcher’s position in the team, prior exercise and warming up minutes before the next day’s game is vital. Just like for a pitcher depending on muscles and physic, MOD is a mechanical device. Once a fire button of the device is pressed, MOD sets up a connection between the batteries and atomizer oil to enable heating. Although the oil and battery combination intensify and fastens the heating process, the 2-3 minutes wait is critical for best results and output in a vaping session. Muscle flexibility hence performance and how long the flexibility lasts in a game is dependent on prior exercise, warm up. Kanthal wiring is the power behind huge vapor clouds from MODs. The technique is used in coiling of an MOD. Vapers that incorporate the MOD hold heat for a longer period as compared to other regular vapers because the MOD vapers run with a resistance of less than 1-Ohm hence the long time for building heat. Mod is the most powerful vaper device as compared to any other technological devices used in vaping. To achieve high intensities of heat, MOD is the most suitable device in a vapor. However, it takes time to build heat because of the sub-ohm technique. As a result, leaving the device to heat for at least two minutes before beginning the vaping session is critical to achieving utmost vapor amount and quality.